The electric heating mantle is a kind of general heating instrument in the laboratory. It consists of a hemispherical heating inner sleeve and control circuit composed of alkali-free glass fiber and metal heating wire. It has the characteristics of fast heating, high temperature, easy operation, and durability. It is the most ideal instrument for accurate temperature control heating test.
- Beautiful, lightweight, temperature control, standard, durable.
- Shell made of one-time molding plastics, anti-corrosive and fine insulation.
- PID intelligent operation control and burnout protection, more accurate and convenient.
- The microcomputer will automatically adjust according to the temperature difference between the heating rate.
- Heating mantle, big heating area, balance in heating and heating up fast.
- Digital display of temperature, more clear.
ZKCL series electric heating mantle is suitable for the following laboratory equipment as heating equipment:
- 1 year warranty service and all life maintenance.
- Technical Egineer are avalible for oversea trainning.
- Free change for some parts
- Remote control technical consult
- Free installation DVD
- Maintenance plan
|Working time||continuous work >8hours|
|Temperature control||Intelligence control. Inside, outside probe|
|Boiling||Water 10~25 mins|
|Insulation||E-glasss fibers, can be temperature 450℃|
1. Can an electric heating mantle be used instead of a water bath?- Yes, heating mantle and water baths are heating equipment.
- If the capacity of the glass reaction equipment that needs to be heated is small, you can choose to use a magnetic stirring electric heating mantle, which can improve work efficiency.
2. What should I pay attention to when using the magnetic stirring heating mantle?- Do not dry burn during use.
- The instrument should be well grounded.
- When it is used for the first time, white smoke and odor come out from the board, which is normal.Because the internal insulation material contains oil and other compounds during the production process, it should be placed in a ventilated place, and the smoke and odor can be used normally after a few minutes.
- Due to the limited temperature resistance of the motor and magnet of the stirrer, the instrument cannot be used for heating only in the heating test, especially the high temperature heating test. Please adjust the motor to rotate or rotate at low speed (idling) to prevent the motor and magnet from being exposed to high temperature Damaged by radiation.
- When the high-temperature heating is over, please turn off the heating first, and wait for a few minutes for the temperature to dissipate before turning off the stirring.
- The heating part has a high temperature, so be careful when working to avoid burns.
- When the humidity is too high, induced electricity may be transmitted to the casing through the insulation layer. Be sure to ground the wire and pay attention to ventilation.If the leakage is serious, please don't use it again, you need to dry it in the sun or dry it in an oven before use to avoid danger.
- If no power is found, first check whether the rear right insurance needs to be replaced.
- When not in use for a long time, please keep the instrument clean and store it in a dry and non-corrosive gas.